Installing System Components 103
Figure 3-14. Removing and Installing the Processor Fan Bracket
Replacing the Fan Bracket
1
Align the fan bracket down onto the bracket base so that the mounting
pins fit correctly into the bracket base. See Figure 3-14.
2
Insert the bracket and engage the release levers to lock it in place.
3
If removed, replace the fans in the fan bracket. See "Replacing a Cooling
Fan."
4
Close the system. See "Closing the System."
Optical Drive
An optional slimline DVD-ROM or DVD+RW optical drive slides into the front
panel and connects to the SATA controller on the system board. The optical
drive is on the right or left side of the system, depending on your chassis.
1 fan bracket 2 release latch
3 fan connector on system board 4 mounting pin
To Next Page
Loading...
