Installing System Components 117
Installing a RAID Battery
1
Connect the battery cable to the connector on the battery.
2
Locate the battery bay on top of the hard drive bays. See Figure 3-1.
3
With the cable oriented toward the back, angle the left side of the RAID
battery into the left side of the battery bay. See Figure 3-24.
4
Rotate the right side of the battery down and press into the locked
position.
5
If not already done, route the battery cable through the right chassis wall.
See "Cable Routing."
6
Connect the battery cable to the battery connector on the storage
controller. See Figure 3-20.
Figure 3-24. Removing or Installing a RAID Battery
1 RAID battery 2 RAID battery cable from storage
controller
3 battery bay
To Next Page
Loading...
