Dell POWEREDGE R710 Series - Installing the Front Bezel; Information Tag; Removing the Information Tag; Replacing the Information Tag

78 Installing System Components
Installing the Front Bezel
1 Insert the hinge tab on the right of the bezel into the slot on the right side
of the system front panel.
2 Rotate the left side of the bezel toward the system.
3 Press the bezel to the system to engage the latch.
Information Tag
The information tag is a slide-out label panel for system information
including the Express Service tag, Embedded NIC1 MAC address, and
iDRAC6 Enterprise card MAC address.
Removing the Information Tag
1 Remove the front bezel. See " Removing the Front Bezel ."
2 Pull the information tag out of its slot in the chassis until it is in the locked
position. See Figure 1-1 and Figure 1-2 in "About Your System" for the
location of the information tag slot.
3 Pull down on the tag until it disengages from the slot in the chassis to
release the top portion of the tag.
4 Pull up on the tag until it disengages from the slot in the chassis to release
the bottom portion of the tag.
5 Remove the tag.
Replacing the Information Tag
1 Remove the front bezel. See " Removing the Front Bezel ."
2 Locate the information tag slot on the front of the system chassis. See
Figure 1-1 and Figure 1-2 in "About Your System" for the location of the
information tag slot.
3 Holding the information tag vertically, slide it into the information tag slot
until it locks into place.