Dell POWEREDGE R710 Series - Removing Expansion-Card Riser 2 from the Expansion-Card Bracket

Installing System Components 127
Figure 3-28. Removing and Replacing Expansion-Card Riser 2
Removing Expansion-Card Riser 2 From the Expansion-Card Bracket
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System."
3 Remove any expansion cards from the expansion-card riser 2. See
"Removing an Expansion Card."
4 Remove expansion-card riser 2. See "Removing Expansion-Card Riser 2."
1 expansion-card riser 2 2 release latch
3 pin collars (2) 4 mounting pins (2)
5 riser 2 connector on system board
1
3
2
4
5