Installing System Components 105
7
If not already done, connect the power and interface cables from the
optical drive to the system board connectors.
a
Connect the power cable to the DVD/TBU_PWR connector on the
front of the system board below the fan bracket. See Figure 6-2 for the
location of the connector.
b
Route the interface cable along the inside right wall of the chassis. See
"Cable Routing" and Figure 3-16 for the 2.5-inch backplane chassis or
Figure 3-17 for the 3.5-inch backplane chassis.
c
Connect the cable to the SATA_A connector on the system board. See
Figure 6-2 for the location of the connector.
8
Close the system. See "Closing the System."
9
Replace the bezel. See "Installing the Front Bezel."
10
Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
Figure 3-15. Removing and Installing the Optical Drive
1 optical drive 2 optical-drive interface cable
3 power cable 4 optical-drive release tab
To Next Page
Loading...
