Installing System Components 109
Figure 3-18. Preparing the Tape Backup Unit and Tray (3.5-in HDD Chassis Only)
6
Install the slide rails or tray on the tape backup unit. Figure 3-18 shows the
3.5-inch tray installation.
7
Align the tape backup unit with the flex bay and slide the unit in until the
locking mechanism engages. See Figure 3-19.
8
If you are installing a SCSI tape backup unit, install the SCSI controller
expansion card in one of the expansion-card slots. See "Installing an
Expansion Card."
9
Connect the power cable to the power connector on the back of the tape
backup unit.
1 drive blank 2 screws (4)
3 tray 4 tape backup unit
To Next Page
Loading...
