Dell POWEREDGE R710 Series - Page 41

About Your System 41
Current boot mode
is set to UEFI.
Please ensure
compatible
bootable media is
available. Use
the system setup
program to change
the boot mode as
needed.
The system failed to boot
because UEFI boot mode is
enabled in BIOS and the
boot operating system is
non-UEFI.
Ensure that the boot mode is
set correctly and that the
proper bootable media is
available. See "Using the
System Setup Program and
UEFI Boot Manager."
Decreasing
available memory
Faulty or improperly
installed memory modules.
Reseat the memory modules.
See "Troubleshooting System
Memory."
DIMM
configuration on
each CPU should
match.
Invalid memory
configuration on a dual-
processor system. The
memory module
configuration for each
processor must be identical.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines."
Embedded NIC
x and
NIC
y :
OS NIC=
<ENABLED
|DISABLED>
,
Management
Shared NIC=
<ENABLED
|DISABLED>
The OS NIC interface is set
in BIOS. The Management
Shared NIC interface is set
in management tools.
Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
"Troubleshooting a NIC."
Error 8602 -
Auxiliary Device
Failure. Verify
that mouse and
keyboard are
securely
attached to
correct
connectors.
Mouse or keyboard cable is
loose or improperly
connected.
Reseat the mouse or
keyboard cable.
Defective mouse or
keyboard.
Ensure that the mouse or
keyboard is operational. See
"Troubleshooting a USB
Device."
Table 1-2. System Messages (continued)
Message Causes Corrective Actions