Dell PowerEdge R730 - Page 117

Steps
1. Using a #1 Phillips screwdriver, loosen the captive screws that secure the network daughter card to
the system board.
2. Hold the network daughter card by the edges on either side of the touch point and lift the card to
remove it from the connector on the system board.
3. Slide the network daughter card away from the back of the system until the Ethernet connectors are
clear of the slot in the back panel.
4. Lift the network daughter card out of the chassis.
Figure 52. Removing and installing the Network Daughter Card (NDC)
1. captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. network daughter card 6. back panel slot for Ethernet connectors
Next steps
1. Replace the network daughter card. See Installing the network daughter card.
2. Follow the procedure listed in After working inside your system.
117