Dell PowerEdge R730 - Installing a 2.5 Inch Hard-Drive Blank (Back); Removing a 1.8 Inch Hard-Drive Blank

Figure 64. Removing and installing a 2.5 inch hard-drive blank (back)
1. hard-drive blank (back)
Installing a 2.5 inch hard-drive blank (back)
Prerequisites
1. Ensure that you read the Safety instructions.
2. If installed, remove the front bezel.
NOTE: This procedure applies only to PowerEdge R730xd systems.
Steps
Insert the hard-drive blank into the hard-drive slot until it clicks into place.
Next steps
Follow the procedure listed in After working inside your system.
Removing a 1.8 inch hard-drive blank
Prerequisites
1. Ensure that you read the Safety instructions.
2. If installed, remove the front bezel.
CAUTION: To maintain proper system cooling, all empty hard-drive slots must have hard-drive
blanks installed.
Steps
Press the release button and slide the hard-drive blank out of the hard-drive slot.
137