Dell PowerEdge R730 - Installing a 3.5 Inch Hard-Drive Blank; Removing a 1.8 Inch Hard Drive from a Hard-Drive Carrier

Steps
Press the release button and slide the blank out of the hard-drive slot.
Figure 66. Removing and installing a 3.5 inch hard-drive blank
1. hard-drive blank 2. release button
Next steps
If applicable, install the front bezel.
Installing a 3.5 inch hard-drive blank
Prerequisites
1. Ensure that you read the Safety instructions.
2. If installed, remove the front bezel.
Steps
Insert the hard-drive blank into the hard-drive slot until the release button clicks into place.
Next steps
If applicable, install the front bezel.
Removing a 1.8 inch hard drive from a hard-drive carrier
Prerequisites
1. Ensure that you read the Safety instructions.
2. Remove the hard-drive carrier from the system.
Steps
1. Turn the hard-drive carrier.
2. Pull the rails of the hard-drive carrier and lift the hard drive out of the hard-drive carrier.
139