PowerEdge T610 Technical Guide 26
• Two point-to-point QuickPath Interconnect links at 6.4 GT/s
• 1366-pin FC-LGA package
• 32 nm and 45 nm process technology
• No termination required for non-populated processors (must populate CPU socket 1 first)
• Integrated QuickPath DDR3 memory controller 64-byte cache line size RISC/CISC hybrid
architecture
• Compatible with existing x86 code base
• Intel MMX™ support
—
Execute Disable Bit Intel Wide Dynamic Execution
• Ability to executes up to four instructions per clock cycle
• Simultaneous Multi-Threading (SMT) capability
• Support for CPU Turbo Mode (on certain processors)
—
increases processor frequency if
operating below thermal, power, and current limits for streaming SIMD (Single Instruction,
Multiple Data) Extensions 2, 3, and 4
•
Intel 64 Technology Intel VT-x and VT-d Technology for virtualization support Enhanced Intel
• SpeedStep
®
Technology
• Demand-based switching for active processor power management as well as support for ACPI
P-States, C-States and T-States
• Support for DDR3L, 1.35V DIMMs for even lower system power (5600 series)
• Support for memory sparing (5600 series)
• AES-NI (hardware encryption assist) for more efficient encryption for uses such as online
transactions SSL (5600 series)
• Intel TXT (Trusted Execution Technology) provides hardware assisted protection against
emerging software attacks (5600 series)
6.3 Supported Processors
For the latest information on supported processors for the PowerEdge T610, visit Dell.com.
Supported Processors Table 10.
To Next Page
Loading...
