Dell PowerEdge T610 - 12 Storage; Overview; Internal Hard Disk Drives; Table 11. Supported Hard Drives

Dell
PowerEdge T610 Technical Guide 38
12 Storage
12.1 Overview
The PowerEdge T610 is available in two different hard-drive configurations:
• 8 x 2.5" hard drives
• 8 x 3.5" hard drives
Each configuration has a unique chassis and hard-drive backplane. Both chassis have eight hot-swap-
capable Serial Attached SCSI (SAS) or Serial ATA (SATA) slots with two LED indicators per slot, two
mini-SAS cable connectors for connecting the backplane to the integrated SAS 6/iR (PERC H200) or
PERC 6/i (PERC H700), a 10-pin planar signal connector, and an 8-pin PDB power connector.
For SATA and SAS mixing, two SAS drives (in bay 0 and 1) are supported with the 2.5" or 3.5"
backplane. In this configuration, one pair of drives will be SAS and the remaining six drives will be
SATA.
12.2 Internal Hard Disk Drives
The T610 system supports up to eight 2.5" or 3.5" hard disk drives. See Table 11 for information on
supported hard drives. For the most up-to-date information on supported hard drives, visit Dell.com.
Supported Hard Drives Table 11.
Form Factor
Capacity
Speed
Type
2 . 5 "
160GB, 250GB, 500GB, 1TB
7.2K
SATA
2 . 5 "
500GB, 1TB
7.2K
NL SAS
2 . 5 "
146GB, 300GB, 600GB, 900GB
10K
SAS
2 . 5 "
73GB, 146GB
15K
SAS
2 . 5 "
50GB, 100GB
N/A
SATA SSD
2 . 5 "
149GB
N/A
SAS SSD
3 . 5 "
250GB, 500GB, 1TB, 2TB, 4TB
7.2K
SATA
3 . 5 "
500GB, 1TB, 2TB, 3TB
7.2K
NL SAS
3 . 5 "
146GB
10K
SAS
3 . 5 "
146GB, 300GB, 450GB, 600GB
15K
SAS
The following additional guidelines apply for hard-drive configurations:
• Up to eight SAS or up to eight SATA drives are supported
• For SAS and SATA mixing, two SAS and up to six SATA drives are possible (two SAS drives must
be installed in slots 0 and 1)
• One mixed 2.5" and 3.5" hard drive configuration is allowed:
o A pair of 2.5" 10,000 rpm SAS drives must be installed with an adapter in a 3.5" hard
drive carrier in drive slots 0 and 1