Rev. A03
August 2022
Dell PowerSwitch S5048F-ON Firmware
Updater Release Notes
This document describes firmware updater information for the PowerSwitch S5048F–Open Networking (ON) switch.
Current Release Version: A03
Release Date: 2022-08
Document revision history
Table 1. Revision history
Revision Date Description
A03 2022-08 Updated to the new release note template. Updated the Requirements, Important
information, New and changed features, Firmware update staging from NOS, Firmware
update staging from ONIE, Resolved issues, and Contacting Dell sections.
A02 2019-04 Updated the Firmware requirements, Firmware update staging, ONIE-based firmware
update, and Contacting dellsections.
A01 2018-10 Updated the Firmware requirements, Firmware update staging, and ONIE-based
Firmware update sections. Added the IP address assignment in ONIE, and Firmware
update invoked manually from ONIE sections.
A00 2017–10 Initial release.
For more information
For information about using the S5048F-ON, see the following documents at www.dell.com/support:
● S5048F-ON Installation Guide
● S5048F-ON Set-up Guide
● Open Networking Hardware Diagnostic Guide
● Dell Configuration Guide for the S5048F-ON System
● Dell Command Line Reference Guide for the S5048F-ON System
● Dell Networking OS9 Release Notes for the S5048F-ON System
For more information about hardware features and capabilities, see the Dell Networking website at https://www.dell.com/
networking/.
For more information about the open network installation environment (ONIE)-compatible third-party operating system, see
onie.org.
Features and requirements
The following requirements apply to the S5048F-ON switch:
Hardware description
● Forty-eight 1/10/25GbE SFP28 ports
● Six 40/50/100GbE QSFP28 ports
1
To Next Page
Need help?
General