282 Troubleshooting: Your Storage Array Software
To find nodes:
1
In the AMW, select
View
Find
.
2
Based on the type of search, select one of these options, and go to the
indicated step:
• Search by name—see step 3.
• Search by special criteria—see step 4.
3
Type the name of the node to be found in
Find Node
. See step 8.
4
Based on the search criteria, select one of these options, and go to the
indicated step:
• Find all virtual disks with RAID level—Go to step 5.
• Find all virtual disks with capacity—Go to step 6.
• Find all free capacity nodes—Go to step 7.
5
To search for all nodes based on their RAID level, perform these steps:
a
Select
Find all virtual disks with RAID level
.
b
Select the RAID level from the list.
c
Go to step 8.
6
To search for all nodes based on their virtual disk capacity, perform these
steps:
a
Select
Find all virtual disks with capacity
.
b
Type the capacity in the GB box.
c
Specify that the capacity to be matched is less than, equal to, or
greater than the capacity entered in the GB box.
d
Go to step 8.
7
To search for all
Free Capacity
nodes with a particular capacity, perform
these steps:
NOTE: This option is not available when the Search by name option is
selected or from the Mappings tab. You must cancel the selection of the
Search by name option to use this option.
a
Select
Find all free capacity nodes
.
b
Type the capacity in the GB box.
book.book Page 282 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
