Planning: RAID Controller Modules 35
9 Management
port Ethernet
connector
Provides a 100/1000 Mbps Ethernet connection for out-of-
band management of the enclosure.
10 Management
port speed LED
Lights green when Ethernet connection is operating at
1000 Mbps.
Lights amber when Ethernet connection is operating at
100 Mbps.
Off when Ethernet connection is operating at 10 Mbps or is
not active.
11 Password reset
switch
Activating this switch resets the password.
12 Battery fault Lights amber when battery backup unit or battery
has failed.
Off when battery backup unit is operating normally.
13 FCIN port 3
LED 1 / LED 0
Displays link rate and port status per the accompanying
host channel LED link/rate table.
14 Cache active or
cache offload
LED
Lights green when on-board controller memory
contains data.
If AC power fails, this LED changes to indicate Cache
Offload status.
If the password reset function has successfully changed the
password, this LED flashes on and off briefly.
15 FCIN port 2
LED 1 / LED 0
Displays link rate and port status per the accompanying
host channel LED link/rate table.
16 System
identification
LED
Blinks blue when system identification switch push-button
on enclosure front panel is pressed.
17 Controller fault
LED
Lights amber when controller fault detected.
Off when controller operating normally.
18 FCIN port 1
LED 1 / LED 0
Displays link rate and port status per the accompanying
host channel LED link/rate table.
19 Controller power
LED
Lights green when controller power is on.
Off when controller is not powered.
Item Component Function
book.book Page 35 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
