82 Configuration: About Your Storage Array
The SMTP mail server is the name of the mail server that forwards the
alert e-mails to the configured e-mail addresses.
5
In
E-mail sender address
, type the valid sender e-mail address.
The e-mail address of the sender (the network administrator) is displayed
on each e-mail alert sent to the destination.
6
To include the contact information of the sender in the e-mail alert, select
Include contact information with the alerts
, and type the contact
information.
NOTE: Including the contact information in the e-mail alert is optional.
7
Select the
e-mail
tab to configure the e-mail destinations.
• Adding an e-mail address—In
e-mail address
, type the e-mail address,
and click
Add
.
• Replacing an e-mail address—In the
Configured E-mail addresses
area, select the e-mail address to be replaced, type the replacement e-
mail address in
E-mail address
, and click
Replace
.
• Deleting an e-mail address—In the
Configured E-mail addresses
area,
select the e-mail address, and click
Delete
.
• Validating an e-mail address—Type the e-mail address in
E-mail
address
or select the e-mail address in the
Configured E-mail
addresses
area, and click
Test
. A test e-mail is sent to the selected e-
mail address. A dialog with the results of the test and any error is
displayed.
8
For the selected e-mail address, in
Information To Send
, select:
•
Event Only
—The alert e-mail contains only the event information.
This alert type is the default.
•
Event + Profile
—The alert e-mail contains the event information and
the storage array profile.
•
Event + Support
—The alert e-mail contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
book.book Page 82 Friday, September 23, 2011 2:46 PM
To Next Page
Loading...
