About this task
The following image indicates the location of the smart card reader and provides a visual representation of the installation
procedure.
Steps
1. Align and place the smart card reader on the palm-rest assembly.
2. Replace the three screws (M2x3) that secure the smart card reader to the palm-rest assembly.
3. Adhere the adhesive tape back on the smart card reader.
4. Connect the smart card reader cable to the connector on the USH board.
Next steps
1. Install the assembly inner frame.
2. Install the battery.
3. Install the WWAN card.
4. Install the WLAN card.
5. Install the 2280 solid-state drive or 2230 solid-state drive.
6. Install the memory module.
7. Install the base cover.
8. Install the microSD card.
9. Install the SIM card.
Removing and installing components
63
To Next Page
Loading...
