Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation
procedure.
Steps
1. Adhere the coin-cell battery to the slot on the palm-rest assembly.
2. Connect the coin-cell battery cable to the connector.
Next steps
1. Install the assembly inner frame.
2. Install the battery.
3. Install the WWAN card.
4. Install the WLAN card.
5. Install the 2280 solid-state drive or 2230 solid-state drive.
6. Install the memory module.
7. Install the base cover.
8. Install the microSD card.
9. Install the SIM card.
10. Follow the procedure in After working inside your computer.
Removing and installing components
65
To Next Page
Loading...
