The following image indicates the location of the keyboard assembly and provides a visual representation of the installation
procedure.
Steps
1. Align and place the keyboard assembly on the palm-rest assembly.
2. Replace the twenty seven (M2x2) screws that secure the keyboard assembly to the palm-rest.
3. Connect the keyboard cable and keyboard backlit cable to its connectors on the touchpad.
NOTE: For models shipped with a USH module, connect the USH cable to the keyboard bracket.
Next steps
1. Install the system board.
2. Install the assembly inner frame.
3. Install the heat sink - UMA or discrete based on the system configuration.
4. Install the battery.
5. Install the WWAN card.
6. Install the WLAN card.
7. Install the 2280 solid-state drive or 2230 solid-state drive.
8. Install the memory module.
9. Install the base cover.
68
Removing and installing components
To Next Page
Loading...
