Steps
1. Connect the eDP/display cable to the connector on the camera.
2. Adhere the eDP/display cable to the display back cover.
3. Adhere the conductive tape and route the eDP/display cable to the display back cover.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WWAN card.
5. Install the WLAN card.
6. Install the base cover.
7. Install the microSD card.
8. Install the SIM card.
9. Follow the procedure in After working inside your computer.
86
Removing and installing components
To Next Page
Loading...
