Installing the System Board
1. Align the system board on the computer.
2. Replace the screws that secure the system board to the palm-rest assembly.
3. Connect the power-adapter port cable, speaker cable, keyboard-control board cable, touch-pad cable, and touch-screen
cable to the system board.
4. Connect the display cable to the system board.
5. Align the screw hole on the display-cable bracket with the screw hole on the system board.
6. Follow the procedures in After Working Inside Your Computer.
Removing the Audio Daughter Board
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. WLAN card
d. hard drive
e. SSD (half length)
f. SSD (full length)
g. fans
h. heatsink
i. memory modules
j. system board
3. Remove the two screws that secure the audio daughter board to the system board.
20
Disassembly and reassembly
To Next Page
Loading...
