Installing the internal chassis speaker
1 Press and hold the tabs on either side of the intrusion speaker, and slide the speaker module into the slot to secure it to the system.
2 Connect the internal chassis speaker cable to the connector on the system chassis.
3 Install the:
a 5.25 inch ODD bracket
b front bezel
c side cover
4 Follow the procedure in After working inside your computer
Air shroud
Removing the air shroud
1 Follow the procedure in Before working inside your computer.
2 Remove the side cover
3 To remove the air shroud:
a Holding the shroud at both the ends, press the tabs[1] and then lift the shroud[2] from the system.
Removing and installing components
35
To Next Page
Loading...
