Installing the PCIe holder
1 Align and place the PCIe holder to the system chassis.
2 Press the holder back until it clicks to the system.
3 Connect the two power cables to the cable slots in the holder.
4 Install the:
a graphical processing unit(GPU)
b side cover
5 Follow the procedure in After working inside your computer.
Rear system fan
Removing the rear system fan
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a side cover
b processor heat sink module(PHM)
3 To remove the rear system fan:
a Disconnect the two fan cables [1] from the system board.
NOTE
: Do not pull the connector by the cable wires. Instead, disconnect the cable by pulling on the
connector end. Pulling on the cable wires may loosen them from the connector.
b Unroute the cable from the cable holder [2] on the PSU bracket.
44
Removing and installing components
To Next Page
Loading...
