Installing the air shroud
1 Place the shroud into its position and make sure that the tab ts into the system.
2 Align the shroud to its locking tab.
3 Press down the shroud until it clicks into place.
4 Install the side cover.
5 Follow the procedure in After working inside your computer.
Memory
Removing the memory module
1 Follow the procedure in Before working inside your computer.
2 Remove the following:
a side cover
b air shroud
3 Press the memory module retention tabs on each side of the memory module.
4 Lift the memory module out of the memory slot on the system board.
WARNING
: Rotating the memory module out of the slot will cause damage to the memory module. Ensure to pull it
straight out of the memory module slot.
Installing the memory module
1 Align the notch on the memory module with the tab on the memory module connector.
2 Insert the memory module into the memory module slot.
3 Press the memory module rmly until the retention tabs click into place.
NOTE
: Do not pull the retention levers up. Always press down rmly on the module until the levers lock into place
unassisted.
4 Install the:
a air shroud
b side cover
5 Follow the procedure in After working inside your computer
36
Removing and installing components
To Next Page
Loading...
