Dell Server User Manual

Dependent RPMs For Remote Enablement
If you choose to install the Remote Enablement feature, you have to install certain dependent RPMs and configure these
RPMs before installing the feature. Install the following RPMs:
• libcmpiCppImpl0
• libwsman1
• openwsman-server
• sblim-sfcb
• sblim-sfcc
The dependent RPMs are available on the
Systems Management Tools and Documentation DVD at srvadmin\linux
\RPMS\supportRPMS\opensource-components\<OS>\<arch>.
NOTE
: On supported SLES 11 and above and Red Hat Enterprise Linux 6 and preceding operating systems, it is
recommended that you install the RPMs from the operating system media, if available.
Installing Dependent RPMs
To install the dependent RPMs not available on the operating system media:
1. Make sure that Pegasus RPMs are uninstalled.
2. Check if the
openwsmand and sfcbd binaries are already installed using make-install. Check by running the
commands: openwsman or sfcbd or you can check the existence of the binaries in the /usr/local/sbin directory.
3. If the binaries are installed, uninstall these binaries.
4. Check for the required dependencies for the
openwsman and sfcbd RPMs listed in the following table.
Table 5. Required Dependencies
Packages Red Hat Enterprise Server SUSE Linux Enterprise Server
Openwsman
OpenSSL
LibXML
Pkgconfig
CURL
Chkconfig
Initscript
SBLIM-SFCC
LibOpenSSL
LibXML
Pkg-config
libCURL
aaa_base
aaa_base
SBLIM-SFCC
SBLIM SFCC CURL LibCURL
SBLIM SFCB
zlib
CURL
PAM
OpenSSL
Chkconfig
Initscript
zlib
LibCURL
PAM
LibOpenSSL
aaa_base
aaa_base
5. Install the dependent RPMs. You can install the RPMs:
– with a single command rpm -ivh rpm1 rpm2 rpm3 rpm4 … rpmN
or
– individually
26

Dell Server Specifications

General

Brand	Dell
Model	Server
Category	Software
Language	English