Table 12. Meta RPMs
Meta RPMs Details
srvadmin-all Installs all the components.
srvadmin-base Installs the Server Instrumentation component. This
component has to be installed before installing any of the
other specific components.
srvadmin-idrac Installs the iDRAC component.
srvadmin-rac4 Installs the DRAC 4 component.
srvadmin-rac5 Installs the DRAC 5 component.
srvadmin-standardAgent Installs the Remote Enablement component.
srvadmin-storageservices Installs the storage services component.
srvadmin-webserver Installs the web server component.
srvadmin-server-snmp Installs the server Simple Network Management Protocol
(SNMP) component.
srvadmin-server-cli Installs the server Command Line Interface (CLI)
component.
srvadmin-storageservices-snmp Installs the storage SNMP component.
srvadmin-storageservices-cli Installs the storage CLI component.
Related Links:
Linux Installer Packages
Custom RPMs Based Installation
The following is an example of custom RPMs-based installation of Server Administrator, including the installation of the
Remote Enablement feature and the Storage Management Service components.
NOTE
: On the Red Hat Enterprise Linux 5.x operating system, DVDs are automounted with the -noexec mount
option. This option does not allow you to run any executable from the DVD. You have to manually mount the DVD
and then run executables.
1. Log in as root to the system running the supported operating system where you want to install the managed
system components.
2. Insert the
Systems Management Tools and Documentation
DVD into the DVD drive.
3. Navigate to the operating system specific directory corresponding to the system.
4. Type the following command:
rpm –ivh Server-Instrumentation/<arch>/*.rpm
add-StorageManagement/<arch>/*.rpm
RemoteEnablement/<arch>/*.rpm
Server Administrator services do not start automatically.
NOTE
: Ensure that you install Server Instrumentation or Remote Enablement before installing Remote Access
Controller or Storage Management.
NOTE
: If you choose to install the Remote Enablement feature, ensure that you install the dependent RPMs
before installing this feature.
5. Start the Server Administrator services after the installation by using the command:
sh srvadmin-services start
54