Dell Studio 1435 - Using the Wireless Switch

Back to Contents Page
 Coin-Cell Battery
DellStudio™1435ServiceManual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery

Removing the Coin-Cell Battery

1. Follow the procedures in Before You Begin.

2. Turn the computer over and remove the base cover (see Removing the Base Cover).

3. Remove the center control cover (see Removing the Center Control Cover).

4. Remove the keyboard (see Removing the Keyboard").

5. Remove the palm rest (see Removing the Palm Rest").

6. Disconnect the coin-cell battery cable from the connector on the system board.

7. Remove the coin-cell battery.
Replacing the Coin-Cell Battery

1. Replace the coin-cell battery and connect the coin-cell battery cable to the connector on the system board.

2. Replace the palm rest (see Replacing the Palm Rest).

3. Replace the keyboard (see Replacing the Keyboard).

4. Replace the center control cover (see Replacing the Center Control Cover).

5. Replace the base cover (see Replacing the Base Cover).

6. Slide the battery into the bay until it clicks into place.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1
coin-cell battery
2
coin-cell battery cable connector