Dell Studio 1435 - Replacing the Display Assembly


11. Remove the two screws (one on each hinge).

12. Remove the display assembly.

Replacing the Display Assembly

1. Place the display assembly in position and replace the two screws.

2. Route the camera cable (optional), power button cable, and display cable through the routing guides and connect the cables to the respective system
board connectors.

3. Replace the screw that secures the display cable.

4. Route the Mini-Card antenna cables through the routing guides.

5. Replace the two screws at the base of the computer.

6. Replace the optical drive (see Replacing the Optical Drive).

7. Replace the palm rest (see Replacing the Palm Rest).

8. Replace the keyboard (see Replacing the Keyboard).

9. Replace the center control cover (see Replacing the Center Control Cover).

10. Replace the base cover (see Replacing the Base Cover).
1
display cable screw
2
camera cable pull-tab (optional)
3
power button cable connector
4
display cable pull-tab
1
display assembly
2
screw (2)
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.