Dell Studio Hybrid - Replacing the Back I;O Board; Removing the Back I;O Board; Installing the Back I;O Board

Back to Contents Page
 Replacing the Back I/O Board
Dell™StudioHybridServiceManual
Removing the Back I/O Board
Installing the Back I/O Board

Removing the Back I/O Board

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the drive cage (see Removing the Drive Cage).

4. Disconnect the flex cable from the I/O board.

5. Remove the two screws that secure the I/O board to the back panel.

6. Gently lift the I/O board away from the back panel.
Installing the Back I/O Board

1. Align the connectors on the I/O board to the slots in the back panel.

2. Replace the two screws and secure the I/O board to the back panel.

3. Reconnect the flex cable to the I/O board.

4. Replace the drive cage (see Installing the Drive Cage).

5. Replace the computer cover (see Installing the Computer Cover).
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: Ensure that you remove all cables out of the way before replacing the drive cage.