Dell Studio Hybrid - Replacing the Back Panel; Removing the Back Panel; Installing the Back Panel

Back to Contents Page
 Replacing the Back Panel
Dell™StudioHybridServiceManual
Removing the Back Panel
Installing the Back Panel

Removing the Back Panel

1. Follow the procedures in Before You Begin.

2. Remove the computer cover (see Removing the Computer Cover).

3. Remove the drive cage (see Removing the Drive Cage).

4. Disconnect the SYS_FAN1 cable from the system board, the black antenna cable from the WLAN card, and the flex-cable from the back I/O board.

5. Remove the two screws on either side of the chassis.

6. Spread the tabs apart on either side of the back panel and gently pull the back panel away from the chassis.
.

7. Spread the tabs apart and gently pull the RF receiver cable away from the back panel.
Installing the Back Panel

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: Carefully note the routing of each cable before you disconnect it, so that you re-route the cable correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
1
back panel
2
latches (2)
1
latches
2
tabs