Dell Vostro 1310 - Page 48

Back to Contents Page
 Power Button and Multimedia Button Pads
Service Manual
Removing the Power Button and Multimedia Button Pads
Replacing the Power Button and Multimedia Button Pads
Removing the Power Button and Multimedia Button Pads



1. Follow the procedures in Before Working on Your Computer.

2. Remove the hinge cover (see Removing the Hinge Cover).

3. Remove the keyboard (see Removing the Keyboard).

4. Disconnect the multimedia-button pad cable from the system board.

5. Remove the M2 x 3-mm screw that secures the power button pad to the palm rest.

6. Remove the M2 x 3-mm screw that secures the multimedia button pad to the palm rest.

7. Slide the power button pad to the left and lift the power button and multimedia button pads out of the computer in one movement.

8. Disconnect the power-button pad cable from the connector at the bottom of the multimedia button pad.
Replacing the Power Button and Multimedia Button Pads



CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: The power button and multimedia button pads should be removed and reinstalled as a single unit.
1
system board connector
2
multimedia-button pad cable
3
power button pad
4
M2 x 3-mm screws (2)
5
power-button pad cable
6
multimedia-button pad cable
7
multimedia panel
8
palm rest
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: The power button and multimedia button pads should be removed and re- installed as a single unit.
NOTE: This procedure assumes that you have completed the removal procedure first.