Installing the solid state drive - SSD bracket
Steps
1. Insert the SSD bracket into its slot on the computer.
2. Tighten the screws that secure the SSD bracket .
3. Install the:
a. battery.
b. back cover.
4. Follow the procedure in After working inside your computer
Removing the solid state drive - SSD
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover.
b. battery.
3. To remove the hard drive:
a. Remove the screws that secure the SSD to the computer [1] .
b. Disconnect the SSD from its connector on the system board [2].
Disassembly and reassembly
17
To Next Page
Loading...
