Installing the hard drive
Steps
1. Insert the hard drive assembly into its slot on the computer.
2. Tighten the screws that secure the hard drive to the computer
3. Connect the hard drive cable to the connector on the system board.
4. Install the:
a. battery.
b. back cover
5. Follow the procedure in After working inside your computer
Removing the hard drive cable
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
c. hard drive
3. Disconnect the hard drive cable from the connector on the hard drive.
Disassembly and reassembly
19
To Next Page
Loading...
