Installing the Solid state drive - SSD
Steps
1. Insert the SSD into its slot on the computer.
2. Tighten the screws that secure the SSD to the computer.
3. Install the:
a. battery.
b. back cover.
4. Follow the procedure in After working inside your computer
Removing the hard drive
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
3. To remove the hard drive:
a. Lift the tab to disconnect the hard drive cable from the connector on the system board [1] .
b. Remove the screws that secure the hard drive to the computer [2].
c. Lift the hard drive from the computer [3].
18
Disassembly and reassembly
To Next Page
Loading...
