Installing the speakers
Steps
1. Insert the speakers into the slot on the computer chassis.
2. Route the speaker cable along the routing channel.
3. Connect the speaker cables to the connectors on the system board and the LED board.
4. Install the:
a. battery
b. back cover
5. Follow the procedure in After working inside your computer
Removing the touchpad
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
c. WLAN card
3. To release the touchpad:
a. Peel away the adhesive tape from over the touchpad [1] .
b. Lift the cable to disconnect the touchpad cable from the system board [2].
c. Remove the screw that connects the touchpad bracket to the touchpad [3].
d. Lift the bracket away from the touchpad assembly [4].
30
Disassembly and reassembly
To Next Page
Loading...
