Installing the touchpad
Steps
1. Align the touchpad with the computer chassis.
2. Tighten the screws that secure the touchpad.
3. Place the touchpad bracket over the touchpad and install the screws to secure it.
4. Install the touchpad connector cables and affix the adhesive tape.
5. Install the:
a. WLAN card
b. battery
c. back cover
6. Follow the procedure in After working inside your computer
Removing the system board
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
c. SSD bracket
d. SSD
e. WLAN card
f. system fan
g. heat sink
h. display assembly
3. Lift the tab [1,2,3,4,6] to disconnect the cables [5] from their connectors on the system board.
32
Disassembly and reassembly
To Next Page
Loading...
