Installing the hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the hinges and provides a visual representation of the installation procedure.
Steps
1. Align and place the left hinge on the display assembly.
2. Install the three (M2.5x3.8) screws to secure the hinge to the display panel and back cover.
3. Align and place the right hinge on the display assembly.
4. Install the three (M2.5x3.8) screws to secure the hinge to the display panel and back cover.
Next steps
1. Install the display bezel.
2. Install the hinge caps.
3. Install the display assembly.
Removing and installing components
61
To Next Page
Loading...
