Table 4. System setup options—Advanced menu (continued)
Advanced
Default: Enabled
VI for Direct !/O Enables or disables the Virtualization technology for Direct
I/O.
Default: Enabled
Integrated NIC Enables or disables the on-board LAN controller.
Default: Enabled
USB Emulation Enables or disables the USB emulation feature. This feature
defines how the BIOS, in the absence of a USB-aware
operating system, handles USB devices. USB emulation is
always enabled during POST.
NOTE: You cannot boot any type of USB device (floppy,
hard drive, or memory key) when this option is off.
Default: Enabled
USB Wake Support Allows you to enable USB devices to wake the computer
from standby or to disable the USB wake support feature.
NOTE: If USB PowerShare is enabled, a device
connected to the USB PowerShare connector may not
wake the computer.
NOTE: To enable wake support for the fingerprint reader
the USB Wake Support needs to be enabled in the BIOS.
To enable USB wake support, complete the steps in the
knowledge base article SLN321473.
Default: Disabled
SATA Operation Allows you to configure the operating mode of the integrated
SATA hard drive controller.
Default: AHCI
Adapter Warnings Allows you to choose if the computer should display warning
messages when you use AC adapters that are not supported
by your computer.
Default: Enabled
Function Key Behavior Allows you to set function key or multimedia key as the
default function key behavior.
Default: Multimedia key
Keyboard Illumination Selects the operating mode of the keyboard illumination
feature.
Default: Bright
Keyboard Backlight with AC Selects the timeout value for the keyboard backlight when an
AC adapter is plugged into the computer.
Default: 1 minute
Keyboard Backlight with Battery Selects the timeout value for the keyboard backlight when
the computer is running on battery power.
Default: 1 minute
Battery Health Displays the battery health.
Camera Enables or disables the camera.
System setup 81
To Next Page
Loading...
