Dell Vostro 3650 - Hard-Drive Assembly Installation; Optical-Drive Assembly Removal

4. Perform the following steps to remove the hard drive from the hard-drive bracket:
a. Remove the screws that secure the hard-drive bracket to the hard drive.
b. Remove the hard drive from the hard-drive bracket.
Installing the Hard-Drive Assembly
1. Replace the hard drive into the hard-drive bracket.
2. Install the screws that secure the hard-drive bracket.
3. Install the hard-drive assembly into its slot on the computer.
4. Close the front-bezel door.
5. Install the screw that secures the hard-drive assembly to the front-bezel door.
6. Connect the SATA cable and the power cable to the hard-drive assembly.
7. Install the:
• bezel
• cover
8. Follow the procedures in After Working Inside Your Computer.
Removing the Optical-Drive Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
• cover
• bezel
3. Perform the following steps to remove the optical-drive assembly from the computer:
a. Open the front-bezel door.
b. Disconnect the data cable and power cable from the connectors on the optical-drive assembly
[1, 2].
c. Close the front-bezel door [3].
d. Remove the screw that secures the optical-drive assembly to the computer [4].
e. Slide the optical-drive assembly to remove it from the computer [5].
11