Installing the Power Switch
1. Push the power switch into its slot and press it in, until it snaps into place.
2. Route the power-switch cable through the metal clip.
3. Connect the power-switch cable to the connector on the system board.
4. Close the front-bezel door.
5. Install the:
• bezel
• cover
6. Follow the procedures in After Working Inside Your Computer.
Removing the Coin-cell Battery
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
• cover
• bezel
3. Open the front-bezel door.
4. Perform the following steps to remove the coin-cell battery from the system board:
a. Press the release latch until the coin-cell battery pops-out.
b. Remove the coin-cell battery from the system board.
17