116 Cables
SATA Cables
NOTE: Using a SATA cable, you can connect only one SATA device to the SATA
connector on the system board.
To connect a SATA cable, hold the cable by the connector at each end and
press firmly into the connector. To disconnect a SATA cable, hold the cable by
the connector at each end and pull until the connector detaches.
1 IDE ribbon cable 2 cable key
3 IDE connector on the system board/drive
1
2
3
1
2
3
book.book Page 116 Monday, January 7, 2008 2:53 PM
To Next Page
Loading...
