Replacing the Computer Cover 119
Replacing the Computer Cover
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION: Your computer is heavy and can be difficult to maneuver. Seek
assistance before attempting to lift, move, or tilt the computer and always lift
correctly to avoid injury; avoid bending over while lifting.
NOTICE: To avoid electrostatic discharge and damage to internal components,
ground yourself by using a wrist grounding strap or by periodically touching an
unpainted metal surface on the computer chassis.
1
Ensure that all cables are connected, and fold cables out of the way.
2
Ensure that no tools or extra parts are left inside the computer.
3
Pivot the cover down and into position.
4
Press down on the cover until it clicks into place.
NOTE: The computer cover should easily snap into place; however, if
necessary, pull back on the cover release latch until the cover is completely
closed, then slide the release latch forward to secure the cover.
book.book Page 119 Monday, January 7, 2008 2:53 PM
To Next Page
Loading...
