Cables 117
Front I/O Panel Cables
NOTE: Most of the front I/O panel, fan, and light cables have similar connectors.
The number of pins and the location of the cable key or missing pin may vary.
To disconnect the front I/O panel cable, hold the cable by the connector and
then pull it away from the system board.
NOTICE: You must align the cable key with the missing pin correctly. Incorrect
alignment can cause damage to the equipment.
When connecting the front I/O panel cable, hold the cable by the connector
and align the cable key with the missing pin on the system board connector;
then press firmly into the connector.
1 SATA connector 2 SATA connector on the system board
3 SATA connector hard drive
1 connector on the system board 2 missing pin
3 cable key
1
2
3
book.book Page 117 Monday, January 7, 2008 2:53 PM
To Next Page
Loading...
