Cards 37
NOTICE: Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the computer cover from closing properly or cause damage to
the equipment.
NOTICE: An incorrectly attached graphics power cable may result in degraded
graphics performance.
8
Connect any cables that should be attached to the card.
See the documentation that came with the card for information about the
card’s cable connections.
9
Replace the screw to secure the card to the chassis.
NOTICE: Before pushing the card retainer back into place, ensure that the tops of
all cards and filler brackets are flush with the alignment bar and the notch in the top
of each card or filler bracket fits around the alignment guide.
1 card connector (seated) 2 card connector (not seated)
3 filler bracket properly aligned
within the slot
4 filler bracket improperly aligned
outside the slot
5 alignment bar 6 alignment guide
1
2
4
3
6
5
book.book Page 37 Monday, January 7, 2008 2:53 PM
To Next Page
Loading...
