DeLonghi EC9335.M - Coffee Delivery; Beverage Selection

30
The rst time you use the appliance, we recommend using the
factory setting (medium grinding) (g. 14), then if you are not
satised with the result, adjust the level according to your per-
sonal taste and the type of coee by setting a ner or coarser
grinding level, referring to the tips in section "4.5 Adjusting the
quantity of ground coee in the lter".
Important:
• Always adjust the coee mill while in operation.
• Adjust one grinding level at a time and make at least 5 coees
before adjusting again.
• Do not remove the beans container while it contains beans.
4.3 The coee lters
The appliance is provided with two coee lters.
The 1 coee lter (C2) has the symbol marked on the
bottom.
The 2 coee lter (C3) has the symbol marked on the
bottom.
For the correct quantity of coee, the ideal level of pressed coee
is marked inside the lters (g. 16). If the quantity is above or
below the level indicated, the result may not be satisfactory. The
next times you use the coee mill, you can adjust the grinding
level using the dial (B2) (see section "4.5 Adjusting the quantity
of ground coee in the lter").
4.4 Grind the coee directly into the lter
1. Place the ground coee lter (C2) or (C3) in the lter holder
(C1) (g. 17);
2. Press the "X2" button if you are using the 2 coee lter;
3. Attach the lter holder to the outlet of the coee mill
(A22), aligning it with , then turning it to the right (g.
18). Grinding begins when the lter holder reaches the
position and stops automatically;
Important: while the appliance is grinding coee, you can per-
form a rinse, or produce hot water or steam at the same time.
4. Once grinding is complete, the light (B16) ashes. Pull
the presser lever (A23) as far as it will go. The force exerted
on the coee is indicated on the lever itself ( )
(g. 19). The light remains on steadily.
5. Remove the lter holder by turning it towards the left.
Important: to adjust the correct quantity ground automatically into the lter hold-
er, see section "4.5 Adjusting the quantity of ground coee in the lter".
If you remove the lter holder from the outlet of the coee mill
without pressing the coee, the light (B16) ashes. To
press, turn the dial (B2) to the position to disable the coee
mill, re-attach the lter holder and pull the lever (A23).
4.5 Adjusting the quantity of ground coee in
the lter
Important: The rst time you use the coee mill, leave the dial
in the position (min). It is normal for you to have to grind the
coee a number of times before nding the correct adjustment for
the right amount of coee.
Perfect dose Too much coee Too little coee
After grinding coee for the rst time, turn the dial (B2) gradu-
ally, starting from the “min” position (see following gure)
until you reach the correct quantity, depending on the type of
coee. The ideal position is within the sector shown in grey in
the following gure.
By adjusting this dial, you can adapt the mill to any type of coee
and to wear of the burrs over time.
5. COFFEE DELIVERY
5.1 Beverage selection
1. Turn the mode selector dial (B8) to select the desired coee
(see section "5.4 Coee beverages").
2. If you use the 2 cup lter (C3), press the "2X" button (B3).
5.2 Delivering the coee
1. Attach the lter holder (C1) to the appliance. To attach
correctly, align the lter holder handle with (g. 10),
then turn the handle to the right until it is aligned in the
position;
2. Place the cup or cups under the lter holder spouts;
3. If you are using small cups, lower the cup grille (A10) to
bring the lter holder spouts nearer the cup. This makes a
better froth (g. 20);