DeLonghi EC9335.M - Page 43

42
PROBLEM CAUSE SOLUTION
The espresso coee drips from the
edges of the lter holder rather than
the holes
The lter holder is inserted incorrectly Attach the lter holder correctly and rotate
rmly as far as it will go
The espresso boiler gasket has lost elas-
ticity or is dirty
Have the espresso boiler gasket replaced by
Customer Services
The lter is clogged, or the perforated
lter is missing or dirty
Clean as described in section "13.4 Coee
lter cleaning and maintenance"
The coee froth is too light (delivered
from the spout too fast)
The appliance settings need reviewing See section "16. How to make perfect coee"
The coee froth is too dark (delivered
from the spout too slowly)
The appliance settings need reviewing See section "16. How to make perfect coee"
No milk froth is formed when making
cappuccino
The ring (A7) is in the "FLAT" (NO
FROTH) position
Push the ring into the "FOAM" position
Milk not cold enough Always use semi-skimmed milk at refrigera-
tor temperature.
The cappuccino maker (A8) is dirty Clean the cappuccino maker as described in
section "10. Cleaning the cappuccino maker
after use"
Scale in the water circuit Descale as described in section "14.
Descaling"
At the end of descaling, the appliance
requests a further rinse
During the rinse cycle, the water tank
has not been lled to the MAX level
Repeat the rinse cycle from point (8) of section
"14. Descaling"
The appliance does not grind the coee There is foreign matter that cannot be
ground in the coee mill
Clean the burrs as described in section "13.8
Cleaning the burrs", making sure you remove
all the beans from the beans container (A2)
before extracting it.
Before putting the burr back, vacuum all resi-
dues from the housing (g. 44).
…
→