14
TYPICAL OPERATIONS
WARNING: THE USE OF ATTACHMENTS AND
ACCESSORIES NOT RECOMMENDED BY DELTA
MAY RESULT IN RISK OF INJURIES.
The following are just some of the many operations that
can be performed with your Delta 1" Belt/8" Disc Sander.
Sharpening a cold chisel on the belt unit with the table
tilted.
Fig. 35
Fig. 36
Sanding aluminum on the disc unit with the table tilted
and using the miter gage as a guide. NOTE: Always sand
on the left (downward) side of the sanding disc, as
shown. Sanding on the right (upward) side of the sanding
disc could cause the workpiece to fly up, which could be
hazardous.
Fig. 37
Fig. 38
Sharpening a wood chisel on the belt unit using a block
of wood to support the chisel and provide clearance for
the chisel handle.
Sanding outside curves on the belt unit with the platen.
To Next Page
Loading...
