To Next PageTo Next Page
Need help?Do you have a question about the Delta 31-695 and is the answer not in the manual?
Warning about chemicals in dust from construction activities and how to reduce exposure.
Details the machine's voltage and frequency requirements for operation.
Essential steps for safely grounding the machine to prevent electric shock.
Describes the main features and capabilities of the Delta 31-695 sander.
Lists all the items included in the product packaging.
Lists the tools necessary for assembling the sander.
Provides an estimated duration for completing the sander's assembly.
Instructions for securely mounting the sander unit onto the assembled stand.
Guide on how to properly adjust the tension of the sanding belt.
Steps for mounting the disc plate onto the drive shaft.
Guide on how to apply the sanding disc to the disc plate.
Instructions for attaching the lower cover for the sanding disc.
Instructions for fitting the backstop onto the sander.
How to turn the sander on and off using the main switch.
How to adjust the tracking knob to ensure the sanding belt runs correctly.
Guide on adjusting the sanding arm to horizontal, vertical, or angled positions.
Steps to ensure the backstop is square with the sanding belt.
Instructions on how to tilt the table to different angles using the lock knob.
How to align the miter gauge slot parallel to the sanding disc.
Information on the supplied dust spout and its connection to a vacuum.
Location for storing the hex wrench supplied with the sander.
Steps to remove the upper guard for sanding curves or changing the belt.
Steps for removing the old sanding disc and applying a new one.
How to sand inside curves using the top sanding drum.
How to sand outside curves using the sanding disc.
How to sand the ends of wide workpieces using the sanding belt.
Troubleshooting steps if the machine fails to start.
Information on obtaining replacement parts, service, and repairs.
General
