INSIDE CUTTING
Inside cutting
is
where the blade must be threaded through a hole
in
the workpiece. The Delta
20"
Scroll Saw has
the capability
of
performing this operation quickly and easily as follows:
Fig. 27
1.
Let's assume you are performing
an
inside cutting operation on a project, similar to the one shown
in
Fig. 27, that
has numerous inside cuts to be made. This can be accomplished quickly with the Delta saw.
In
Fig. 27, the operator
has just completed one of the inside cuts and must move to the next hole.
2.
Loosen lock handle (A) Fig. 28, and raise holddown bar (B). Release blade tension by moving tension lever
(C)
forward and loosen upper blade holder screw using the quickset blade changing wrench (D). Move the blade forward
and insert it into the next hole
in
the pattern, as shown. Reassemble blade back into upper blade holder and tighten
upper blade holder screw with wrench (D).
3.
Remove quickset blade changing wrench and move
tension lever
(C)
Fig. 29, to the rear,
as
shown. Lower hold-
down and you are ready to make the next inside cut.
Fig. 29
13
To Next Page
Loading...
