MAINTENANCE
LUBRICATION
A
To keep the scroll
saw
operating
at
peak
efficiency, we
recommend that a
simple
maintenance
procedure
be
performed
after
approximately
each 20
hours
of use.
Proceed as follows:
1. MAKE CERTAIN THE MACHINE IS DISCON-
A
NECTED FROM THE POWER SOURCE.
2. Remove four screws (A) Fig. 30, and remove side
panel
(B) from the scroll saw.
Fig. 30
3.
Release blade tension by pulling tension lever (C)
Fig. 31, forward as shown.
Fig.
31
4. Lubricate
the
shafts of
the
two special screws (D)
Fig. 32, with a few drops of light
machine
oil in the areas
where
they
pass through the
connecting
link (E). NOTE:
DO NOT REMOVE SPECIAL SCREWS TO LUBRICATE.
5.
Remove two pivot bolts (F) Fig. 32.
D
Fig. 32
6.
Thoroughly
clean
grease
from shafts (G) Fig. 33, of
both pivot bolts (F) and lubricate shafts
(G) with a few
drops of light
machine
oil.
7.
Reassemble
two pivot bolts (F) Fig. 33, to machine.
8. Replace side panel removed in STEP 2 and reapply
tension to the blade.
Fig. 33
14
To Next Page
Loading...
